An open-source 3D printer is a device where all or some of the materials required to create the printer and the software that ...

Learn how a teenager built a six-figure business with 3D printing and low-cost resources in high school.

I have several 3D printers, and I’ve always been satisfied with using either Repetier or Marlin on all of them. There are a few other firmware versions that could run on my hardware, but those two ...

Sitting at my PC today and looking back at 2025, there are a handful of prints that stand out to me as the best that I've seen this year in the realm of computing accessories. Once you get past the ...

Murray Leinster’s short story Things Pass By, published in 1945, includes what may be the first description of 3D printers: But this constructor is both efficient and flexible. I feed magnetronic ...

Spark X continues to evolve, combining user-centred design, AI-assisted printing, and effortless maintenance. Our goal is to make 3D creation universally accessible, reliable, and inspiring, so anyone ...

Not only does this orange and white PC build look absolutely gorgeous, but it also uses a completely 3D-printed PC case. With clever use of a Minifactory Innovator, and two Ultimaker 2 Extended+ 3D ...

I’ve always felt it was a waste of time to cry over things I can’t change. However, as I sat on my bedroom floor recently, struggling to twist open the glucose sensor my daughter needs to survive, ...