Note - all references to issuing commands and displaying data refer to the use of BQStudio and an EV2400. Also just to provide context, I have a BQ27520EVM connected to a BQ41Z50EVM, and my ultimate ...

Page 4 of SLUUD32 says "Find the latest firmware in the appropriate BQ41Z50 folder on www.ti.com". Where can the actual *.bq.fs file be found (need the file, or a better link than just www.ti.com).

The open-loop gain in the simulation result (59.9V/mV) is smaller than the minimum value (70V/mV) in the datasheet. Does this mean that the gain in the SPICE model is smaller than the gain in the ...

I have some questions about the manual. 1.Which register does this reset refer to?FRAME_CNT_THRESHOLD(46H) or FRAME_CNTx(45H)? 2.Is the error counter mentioned in the ...

We are using TCAN1145-Q1 to judge it is wake up frame from the network or not by CANINT register bit. While we found when there are other nodes receiving WUF, this TCAN1145 node cannot assert register ...

Reg63 ”DAC Channel Volume Control's Soft-Step control”...Soft-Stepping is 1 step per 1 or 2 DAC Word Clock I would like to check whether there is any pop noise when switching from maximum volume to ...

I met the similar problem when using ads1274EVM-PDK, And of course, the USB device was enumenated under NI-VISA USB Devices: My PC is Windows 10 64 bit. In C:\Program Files (x86)\ADCPro\drivers ...

I'm using the ADC128S102 EVM and I did some measurements I want to save to a log file. I the GUI there is such option but I cant find the location the Log file is generated to. Please help here.

I'm using CC2340R5-Q1 MCU and SDK simplelink_lowpower_f3_sdk_8_10_01_02. I use the basic_ble project and integrate i2ctarget into it. If I2C receives I2C data, it ...

We upgrade our design to use 8 Giga Bytes of DDR4 using 2 Micron chip MT40A4G8NEA-062E:F. I used the SDK 09.02 and sysconfig tools online. Our DDR4 chip are wired with 1 chip select. 1 - Do I need to ...

We use gmake tool to build our AM62Ax project in windows operation system, sometimes the compiler report error log as the screenshot show,but if we try to rebuild the ...